Electronics > Projects, Designs, and Technical Stuff
723 psu issue
<< < (4/7) > >>
xavier60:
I must mention also that it will not be capable of safely supplying 20 amps without  pre-regulation.
And I don't think that MOSFETs are suitable for paralleling. I haven't really looked into it.
xavier60:

--- Quote from: xavier60 on November 15, 2018, 12:29:29 am ---This should be able to made to work with some experimenting.
Q2 and associated circuitry is an adjustable current source which sets a voltage drop across R5 which determines the current limit threshold.
One unknown is how much Base current that the 723's current limiter transistor needs.

--- End quote ---
This idea had already been thought of in post #27, https://www.eevblog.com/forum/projects/linear-lab-power-supply/25/
m3vuv:
hi xaviar60 any idea what sort ov size pot v3 should be in the schematic you sent?,cheers Paul m3vuv.
m3vuv:
i have some of these(op05cp intrument amprifier ic's),could i use one somehow to amplify the voltage generated across the sense resistor to feed the cl/cs pins on the 723 somehow?.
xavier60:

--- Quote from: m3vuv on November 19, 2018, 12:02:18 am ---hi xaviar60 any idea what sort ov size pot v3 should be in the schematic you sent?,cheers Paul m3vuv.

--- End quote ---
The usual 10k linear pot. It will be ok with a lower value so long as R1 is of a value that will pass enough current to keep D2 forward biased at times when the unregulated rail drops in voltage.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod