Electronics > Projects, Designs, and Technical Stuff
A problem about my switch mode Power supply
(1/1)
China NewBoy:
 i made a 24V switch mode power and it is suppoed to output the current of 2A ,but ,after i did some experiments,i found the Volt drop down to 22V when the LOAD is 12ohm. (there is weird sound -ZiZi)  (pdf 's  left upon part is the power supply unit) ,i think the circuit around OPA or tl431 is the key ,however, i just cant adjust it properly.

my SchDoc Pdf
my PCB Doc

 hope the problem solved :-+
Simon:
If you start another topic twice you will be banned! i hope that is clear enough for you.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod