Electronics > Projects, Designs, and Technical Stuff
A problem about my switch mode Power supply
<< < (4/4)
ocset:
your transformer is not phased correctly for it to be a flyback.
(The  dots are in the wrong place)
China NewBoy:
thank you , i knew that my sch have the transformer mistake but my PCB doc is not wrong .....just too lazy to correct the sch
China NewBoy:

--- Quote from: China NewBoy on November 19, 2019, 10:36:20 am ---thank you , i knew that my sch have the transformer mistake but my PCB doc is not wrong .....just too lazy to correct the sch

--- End quote ---
and the problem have been solved ,its c2_cha
 ..... my stupid  mistake, i take a 1uf cap to solder on c2_cha's place.
and it cause the  feedback volt too low
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod