Electronics > Projects, Designs, and Technical Stuff
A problem about my switch mode Power supply
(1/4) > >>
China NewBoy:
 :-// i made a 24V switch mode power and it is suppoed to output the current of 2A ,but ,after i did some experiments,i found the Volt drop down to 22V when the LOAD is 12ohm. (there is weird sound -ZiZi)  (pdf 's  left top part is the power supply)

My problem 's video :   https://www.youtube.com/watch?v=oZOkMZSDCR8&feature=youtu.be
China NewBoy:
my SchDoc Pdf
China NewBoy:
my PCB Doc , hope the problem solved :-+
China NewBoy:
sorry,i forget to mention that the PSU part is in the left upon of the SCHDoc ,and i think the circuit around OPA or tl431 is the key ,however, i just cant adjust it properly.
xavier60:
I think R19 should connect to the rail being  regulated, 24V.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod