Electronics > Projects, Designs, and Technical Stuff
A problem about OPAmp and TL431
(1/1)
China NewBoy:
             How  the voltage between the 2.3 pin of TL431 will change(increase or drop?)   after the input of op amp A and op amp B increases?
 
   the opa A  and opa B are on the same chip
iMo:
If the voltage at the pin1 against pin2 (gnd) of the TL431 goes above 2.5V the voltage between its pins 3 and 2 drops from Vxyz to 2.5V.
In the schematics above there is a divider 147k/3k thus the voltage at pin 1 most probably never goes above 2.5V.
China NewBoy:
thanks,the problem is solved now..casued by my stupid mistake
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod