Electronics > Projects, Designs, and Technical Stuff
Am I going insane... D Sub 9 connectors
<< < (3/3)
T3sl4co1l:
You'd need an extension actually, not a gender changer.

The former is male to female, with nuts on both sides.  The latter is male to male (or vice versa).

Tim
gibbled:
these are aluminum but often they are made of brass...
mariush:
4-40 standoffs and spacers like in the picture above: https://www.digikey.com/short/p01jnw

4-40 screws ... small and long : https://www.digikey.com/short/p01jdp

Absolute lowest effort solution ... 2 very long screws and two spacers (tube like in picture above) .... insert screws through both connector holes and screw the extension on the thread on the other side.

Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod