Electronics > Projects, Designs, and Technical Stuff

Am I going insane... D Sub 9 connectors

<< < (3/3)

T3sl4co1l:
You'd need an extension actually, not a gender changer.

The former is male to female, with nuts on both sides.  The latter is male to male (or vice versa).

Tim

gibbled:
these are aluminum but often they are made of brass...

mariush:
4-40 standoffs and spacers like in the picture above: https://www.digikey.com/short/p01jnw

4-40 screws ... small and long : https://www.digikey.com/short/p01jdp

Absolute lowest effort solution ... 2 very long screws and two spacers (tube like in picture above) .... insert screws through both connector holes and screw the extension on the thread on the other side.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod