Electronics > Projects, Designs, and Technical Stuff

Any MOSFET similar of ULN2003?

<< < (5/6) > >>

Zero999:

--- Quote from: OlegH_ua on September 11, 2018, 12:02:20 pm ---
--- Quote from: ogden on September 11, 2018, 11:35:58 am ---Min 8.5V supply :(

--- End quote ---

COM pin supply voltage usually is equal to load power, so for most cases 8,5V min is normal.
Also from datasheet's paragraph 9:
"Though 8.5 V minimum is recommended for Vcom, the part will still function with a
reduced COM voltage that has a reduced gate drive voltage and a resulting higher Rdson"

--- End quote ---
It would be nice if there was a graph of the on resistance vs power supply voltage, on the data sheet.

MasterT:
Toshiba has IC operating as low as 2V: TBD62783APG

Long list sourcing/ sinking types, MIN voltage 2V, 2.5V, 3V, 7V:
https://www.mouser.ca/Toshiba/Semiconductors/Power-Management-ICs/Gate-Drivers/_/N-41fcp?P=1z0zkx4

Evan.Cornell:
Take a look at Toshiba TBD62003A. Similar idea to TI TPL7404L (FETs instead of Darlingtons), but without the 8.5V requirement.

JPortici:
Diodes inc make a ULN2003 compatible that uses logic level mosfets, i used it in a project some months ago

koendv:
tpl7407ldr. Texas Instruments. Plug-in compatible.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod