| Electronics > Projects, Designs, and Technical Stuff |
| Arduino Nano serial control of parallel AD9854 Ebay module |
| (1/1) |
| moffy:
I purchased a AD9854 Ebay module expecting to control it by its serial interface. However the module designers had seen fit to enable only the parallel interface. It's a difference of about 16 pins vs 4-5 pins for the serial. There is also the issue of the 5v to 3.3v conversion from the Nano to the AD9854 module. So I designed a serial to parallel interface using a couple of 74AHC595 serial to parallel shift registers. The 74AHC version is 5v tolerant when run from 3.3v, and is also available in a 16 pin DIP package which meant I could use some vero board. By playing with the pin connections I was able to minimise the number of jumpers on the vero board. I wrote some code for the Nano and it works quite nicely. I must say that the module seems to perform very well. Connections between Arduino Nano and AD9854 Serial to Parallel Interface Board. NANO AD9854 Interface Board(AD9854_sp_sch.pdf) A0 RST_5 A1 CLK A2 /OE A3 DATA A4 /WD_5 GND GND |
| hongselectronics:
Did you get the quadrature signals working on this module? I am very interested in seeing the code for this. I just got an AD9854 module, and I am pretty shocked by the lack of Arduino support for this amazing module. Especially given the fact that it is directly mentioned in Art of Electronics 3rd Edition. |
| moffy:
Yes I did get it working. I was able to set frequency etc. I'll see if I can look up the old code and post it here. I'll have to search for it a little. The project is an Atmel Studio v 7.0 |
| Navigation |
| Message Index |