Electronics > Projects, Designs, and Technical Stuff

Best way to connect power pins

(1/1)

c64:
4 layer board:
layer 1 - signal layer
layer 2 - ground plane
layer 3 - power plane (orange line is split between VCCINT and VCCIO)
layer 4 - signal layer

TQFP chip on top layer (layer 1), 0.5mm pitch.

How to connect power pins? I see 3 options. I think option A is no good. Not sure which one is better - B or C. B has shorter traces than C. But C both VCC and GND go close to each other all the way to power planes.

How would you connect power pins?

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod