| Electronics > Projects, Designs, and Technical Stuff |
| BMS balance connector is unlabeled. Can you figure out which side is B-? |
| (1/1) |
| weinbergerc:
I ordered this cheap BMS from ebay. It uses a the same balance connector as my battery pack, but the location of B- on the battery's connector and on the BMS's connector extension are opposite! The connector extension has one black lead (this extension shipped with the BMS) which I assume is B-. Since the BMS board is unlabeled, I'm not sure if the lead extension is just wrong, or if the board actually has its B- wire opposite of my pack. =/ What can I do? |
| oPossum:
The harness shown in your last picture looks correct. Pin one of the PCB is designated by a square pad, and on the bottom it goes to some ground plane, so that is most likely to be the B- connection. |
| Navigation |
| Message Index |