| Electronics > Projects, Designs, and Technical Stuff |
| Boost converter + lipo charger/battery protection circuit |
| << < (3/6) > >> |
| KL27x:
--- Quote ---Those are copper. --- End quote --- :o Good luck with that. |
| aiq25:
--- Quote from: KL27x on March 18, 2019, 12:43:50 am --- --- Quote ---Those are copper. --- End quote --- :o Good luck with that. --- End quote --- Are you talking about the IC pads? |
| KL27x:
Every pad on the entire board. Did you run DRC (Design Rule Check?) If you run DRC and it passes, I'd check what clearances you have in your DR's. If those box outlines are in copper, you have multiple obvious clearance issues on this board. |
| aiq25:
--- Quote from: KL27x on March 18, 2019, 01:05:51 am ---Every pad on the entire board. Did you run DRC (Design Rule Check?) If you run DRC and it passes, I'd check what clearances you have in your DR's. If those box outlines are in copper, you have multiple obvious clearance issues on this board. --- End quote --- Oh, I think I know what you mean now, I was bit confused. No the outlines are not copper actually, at least shouldn't be so I will double check this. I did run DRC and no errors. I will post back after double checking. Thanks for pointing it out. |
| KL27x:
Ok. Then I suspect that is either the soldermask or paste layer. Curious that it is the same color as the top copper layer! |
| Navigation |
| Message Index |
| Next page |
| Previous page |