Electronics > Projects, Designs, and Technical Stuff
Breath Controller for synths w/ BC input: need design help
<< < (5/6) > >>
artico78:
I received it, its the plastic pipe connection broken, i think i will made it with 3D printer, the tube glue don't work. Ive seen inside an Hall sensor and a magnet with a rubber connection. There are 2 operational in smd tecnology and smd resistor and capacitors like the schematic of BC2 i think the difference is only with the outside package, its different than sensor we are using. ive to made some photos.
artico78:
Like i promised, some pictures, schematics is the same as BC2 if u take a look at resistors under hall sensor u can see two 152 (1.5k) and two 103 (10k) u can control on pictures i sent.
I forget to take the code of op amps
artico78:
Here all the things we need for a BC3 clone http://hardwarium.ru/?p=26 i've that pressure sensor and i will try to do all in smd technology
stubbsonic:
Thanks for all those images & links, Artico78. That's very useful. I'll have to see what I can glean from the Russian web-page using some kind of translator.

I got a circuit design from Chuck White (THANK YOU, CHUCK!!). I have assembled it on breadboards a half-dozen times, but have not gotten it to work yet. At some point I got busy with other stuff and was waiting for a block of time to work uninterrupted and troubleshoot.

More soon.

artico78:
I'm waiting for some components, i've already the sensor in 2 versions, i made this BC3 in photos work and i'm really happy, all go fine.
I translated russian site in Italian, when components will arrive i will assemble on a bread board, for now i will simulate all on proteus ISIS to see all the parameters
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod