Electronics > Projects, Designs, and Technical Stuff
bringing solder paste back to life
(1/1)
ETITsynthesizer:
I have some T4 size leaded solder that was pretty much almost completely dry when I removed the seal for the first time immediately after shipment. I need either a tacky flux that is designed for reflow manufacturing in an oven or I will maybe thin it out with isopropanol.
I found this but it is a bit more expensive than what I want to pay. it says "tacky" so that makes me think it is good for solder paste. is that correct?
https://www.amazon.com/Clean-Tacky-Soldering-Flux-Grams/dp/B07DCD9M3P/
how does this compare?
https://www.amazon.com/gp/product/B005DNR01Q/
Navigation
[0] Message Index
Go to full version