Electronics > Projects, Designs, and Technical Stuff

Buck converter with pass transistor

(1/1)

anishkgt:
Hey All,

First time here so i did not find an appropriate category for my Title.

I am trying charge a bank of capacitors BCAP0360 in a 3s2p configuration. The Buck converter U1 (AP3211) sets the output voltage at 8.1v and a bypass N-MOSFET Q1 (SQP60N06) to charge at a higher current.

Questions:

* I am just not sure if i have Q1 connected the correct way to function as a bypass transistor for higher current about 50A (Max).
* Is the inductor necessary here ? Would the inductor be able to handle the rated current ?

TheHolyHorse:
The AP3211 has an internal switch, SW pin. Inductor, diode and output caps should be connected to that pin. I suggest you look at the example in the datasheet.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod