Electronics > Projects, Designs, and Technical Stuff

Building a high power (100 watts) attenuator

(1/2) > >>

sundance:
Hi everyone,

I'm trying to build a dummy load using one of those 50 ohms/150 watts used flange mount termination resistors you'll get on the internet. The plan is to mount this resistor (G150N50W4B) on a CPU cooler (w/fan) capable to dispose some 100 watts. The resistor will sit in a small metal enclosure along with a BNC connector.
Now I thought it would be very handy to have an additional output that is 30 dB below the input for monitoring / measurement purposes. I've calculated a PI attenuator and selected resistors from the E96 series. Since I can't use 52 ohms shut resistors, I'll have to be happy with a VSWR of 1.06. I'd like to use the dummy load up to 450 MHz, maybe 1.2 GHz if possible.

tldr; -> and here's the challenge:
Is it possible to build a 30 dB attenuator with only one PI network?

Usually I'd split this into 3 x 10 dB to minimize the stray capacities and crosstalk over the series resistors. Unfortunately I can't build a 10 dB attenuator with a 50 ohms input shunt unless I'd tolerate a VSWR of 1.6.
So how could a 30 dB att mechanically being built? Maybe it would help to to split the series resistor to 3 x 250 ohms and intruduce shielding chambers for each resistor?

Any other ideas would greatly be appreciated...


German_EE:
The first thing that I would do is make the attenuator 40 dB, this means that 51 ohm resistors are required at either end and the VSWR is reduced. At 40 dB you will need a 2.5K ohm resistor for the middle leg, fabricate this using 5 x 500 ohm non-inductive resistors with some sort of screening between the sections and everything should be OK.

Feed your 100W into this and the result will be 10dBm or 0.01 watts which means your test equipment won't even break into a sweat.

There is however an alternative approach here using a power tap and the following link may be of interest:

https://www.qsl.net/sz1a/download/build%20an%20rf%20power%20meter.pdf

bd139:
You can buy flange mount attenuators surplus on aliexpress. 4x 10dB steps should give a reasonable power distribution.

sundance:
@BD139 & German_EE:
Thanks a lot for the valuable input.
To be honest, the original plan was to have a 40 db attenuator but I thought this was not possible to achieve. But the design with seperated sections sounds feasible.
And I didn't know these flange attenuators existed! Definitely trying to get some of those...

bd139:
Typical example: https://www.aliexpress.com/item/ATTENUATOR-FLANGE-150W-20dB-50-ohms-RF-Termination-Microwave-Resistor-High-Power-Dummy-Load-150WATT-50OHM/32883203445.html

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod