Author Topic: Building a pocket oscilloscope  (Read 1249 times)

0 Members and 1 Guest are viewing this topic.

Offline z_tjona

  • Newbie
  • Posts: 1
Building a pocket oscilloscope
« on: May 22, 2015, 04:20:57 am »
Hi, I'm new in this forum,
I just started with this proyect in my university: I need to build an oscilloscope with a TFT. it requires a 200Khz frequency, and to calculate Vrms.
My principal question is what could be the best way to control it ?
An fpga or a microcontroller?
I have a STM32f4discovery but, I began to doubt because I though that maybe the uC can't reach the frecuency (i haven't tried with the Stm yet)
Any idea or some experience would be forever appreciated.
ajaajaj
 

Offline Skimask

  • Super Contributor
  • ***
  • Posts: 1425
  • Country: us
Re: Building a pocket oscilloscope
« Reply #1 on: May 22, 2015, 04:41:26 am »
You asking because there isn't any knowledgeable people around your "university"?
Time to change majors...
I didn't take it apart.
I turned it on.

The only stupid question is, well, most of them...

Save a fuse...Blow an electrician.
 

Offline Marco

  • Super Contributor
  • ***
  • Posts: 4990
  • Country: nl
Re: Building a pocket oscilloscope
« Reply #2 on: May 22, 2015, 07:12:13 am »
In the absence of knowledgeable people LTG. The fourth link has source code for the STM32F429-Discovery-Board.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf