Electronics > Projects, Designs, and Technical Stuff

Cant find jumpers for more than 2 pins...

(1/3) > >>

Pete66:
Hello

You've all seen these 2 pin jumpers.
I have a CPLD development board that I designed and I need some 3 pin jumpers.

Anyone know if they make this type of jumper in a 3 pin design?

Thanks

Psi:
Even if they do, one of them is likely going to cost you more than 2x 2pin jumpers and 2x 2pin headers combined.
They will be rare and so will be expensive.

I've never seen a 3 in a row, but i have seen 2x2 jumper blocks

digsys:
I've used / have 5.08mm jumpers (for HV stuff), and when needed, jammed a extra pin down the center. A bit ugly but works :-)
I did find these -
https://www.conrad.com/p/shorting-jumper-contact-spacing-254-mm-508-mm-pins-per-row2-tru-components-tc-05305-101-10-00-content-1-pcs-1560877
Look for 5.08mm ones

Pete66:
There are 5 pins.  I need to jump 3 in a row.
pins 1,2 and 3 or pins 3,4, and 5.

I cant believe nobody makes these.  Ill have to use a dupont connector and put wires in it to connect all 3.  Its gonna look ugly.

screwbreaker:

--- Quote from: Pete66 on April 02, 2019, 06:53:35 am ---There are 5 pins.  I need to jump 3 in a row.
pins 1,2 and 3 or pins 3,4, and 5.

--- End quote ---

From this seems that pins 1,2 and 4,5 are always connected together. You just need to jumper pin 2,3 or 3,4.
What I'm missing?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod