Electronics > Projects, Designs, and Technical Stuff
Can't simulate simulink model
(1/1)
Achu:
I'm trying to simulate the following chopper controlled dc motor in MATLAB Simulink using a PI controller. Now without the freewheeling/flyback diode across the motor terminals I can simulate the model to get the desired speed output. But with the diode the motor seems to run at full speed and is uncontrollabe. Is it a glitch in the software? or is there anything I can do about it in the software?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod