Electronics > Projects, Designs, and Technical Stuff

Capacitor Dominatrix

(1/3) > >>

moontide:
I think this would be useful for me.


Is a cap charged, is it safe?

A series of resisters with each leg going parallel resisters. Perhaps an LED indicator.


This would help me moving forward in diagnostics safely.


I assume a multimeter would do something very similar. In that case, more training!!!!




Thoughts?

vealmike:
Why not hire an underling to count the electrons in and out? Y'know with one of those clicker counters like bouncers used to use on nightclubs when I were young and all this were fields as far as the eye could see.

(I'm not really sure what you are asking.)

DaJMasta:
I'm not sure many capacitors could really appreciate a good dominatrix  :-DD


You're looking for a device to discharge capacitors?  A metal probe with an insulated handle and a 100k+ resistor in series to ground should do a pretty good job, but most of the time it's best practice to include bleeder resistors in your design to discharge them safely in a few seconds after power-down, and for all but really large capacitor banks, that can be done with fairly high value resistors and minimal lost power.

Something like a multimeter's low impedance mode (if it has it) can also be used to quickly discharge caps safely.

SiliconWizard:
I didn't know there was such a thing as S&M electronics. :-DD

Benta:
It only works for leather or latex capacitors. In a pinch also with rubber types. Also be aware that if it's done correctly, it can be painful.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod