Electronics > Projects, Designs, and Technical Stuff
Chinese 0-30v 3a psu issues
m3vuv:
those last readings were from u3 pins btw.
m3vuv:
i changed d9 and its fixed it,cheers everyone,its been a pain but feel ive learnt something,it was the comment about both op amp inputs beeing equal if there in the loop led me too it,many thanks all.,also the spike hs gone in cc mode at turn off too.
m3vuv:
well maybe i spoke too soon,just noticed i cant get the output below 35mv,rv1 does nothing,earler i dis swap c3 for a 100uf from a 47uf,is that the cause?,cheers Paul m3vuv.
Ysjoelfir:
You do notice that there is an edit function implemented into this forum software?
m3vuv:
in a word no i didnt,anyway swapped u2 and it goes down to 3mv,think thats good enough for me.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version