Electronics > Projects, Designs, and Technical Stuff

Christmas lights

(1/2) > >>

codemonkeyrawks:
I want to drive some Christmas lights from a Arduino but not quite sure how to do it and multiplex the pins together since the arduino only has 12 pins. I am thinking of using a 12 relays and need to output 40 lines. Any Suggestions :P

tinsmith:
Here's one. Do you really need to set it up as a 40-element matrix display? Strand lights usually don't. Common effects like the "racing" cycle tend to use sub-arrays tied to a common signal.

LEDs also don't need to be at logic high all the time in order to appear on. Even a fairly low duty cycle will usually look like it's persistently lit, but you'll start losing some apparent brightness if you go too far. Because of this, a common technique for arrays of LEDs is to set up an m x n matrix and strobe over it.

tyblu:
Shift registers are great for this type of low-update rate and pin count situations. 4094 is serial to parallel converter. You'll need a driver if the lights aren't LEDs, like the ULN2803A.
More resources: http://www.lightorama.com/products.html
http://www.avrfreaks.net/index.php?name=PNphpBB2&file=printview&t=18054

badSCR:
I lave light-o-rama....  Very good company to do business with.    ;D ;D

I use there controllers for my display.  ;D   I am a very happy customer, and my neighbors love my display.
Buy your lights and stuff when they go 75% off for the after christmas sale.


House91320:
I am blanking on the name but there chips that will do this.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version