Electronics > Projects, Designs, and Technical Stuff
Class D amplifier as four quadrant Power Supply - Stupid idea?
(1/1)
ulwur:
Hi! I have searched the forum for a topic like this but haven't found anything useful.

 I have an idea.. Trying to design a 4-quadrant power supply for my bench, and got the idea to use a Class-D amplifier circuit for the output stage to minimize the losses.

Is this a good idea? Will it work? Have it been tried?

Most of the time the supply will, ofcource, be working like a simple Buck voltage regulator.
Ideas on how to create the PWM waveform? The resolution of the PWM would have to be something like 6000 steps to create +-30 volts with 10 mv resolution. The input to the PWM Circuit is analog so I cant use a Micro to create the PWM signal.

Is it too complicated? Am I Better off with a traditional Class AB amp with switching buck pre-regulators to keep the losses manageable?
bitseeker:
A four-quadrant power supply is able to sink as well as source power. In other words, it's both a power supply and an electronic load, depending on which quadrant it's operating in. So, you'll need to understand how both types of equipment work.

A Class-D amplifier is a switch-mode power supply (SMPS). Search for that and you'll find lots of information. Note that they are more complex than linear power supplies.
NiHaoMike:
Amplifiers generally are designed to supply predictable loads, not wildly varying ones.
David Hess:
A bipolar (positive and negative, not transistor type) output class-D amplifier can make a great output stage for a 4 quadrant power supply with the usual caveats about noise and stability.  Higher power units do exactly this when high power density is required.

Just beware that when operating as a load, the power is transferred to the internal power supply which may rise out of bounds if not controlled.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod