Electronics > Projects, Designs, and Technical Stuff

Coil gun

(1/2) > >>

House91320:
i am going through the proses of rebuilding my coil gun an would like to make i portable would i be possible to use a pwm signal instead of AC.

Simon:
you will need you PWM signal to be fed via a Hbridge as it has to be dual polarity for the voltage multiplier to work

House91320:
Ya that is what i was thinking of doing i just wanted to check that.

Simon:
but it needs to be 50% anyhow

Zero999:
You don't need an h-bridge, a half bridge will do.

What voltage do you need? Using a flyback transformer is normally the best way to go.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version