Electronics > Projects, Designs, and Technical Stuff

Connection to Electrodes on Glass

(1/2) > >>

nickbild:
I need to make an electrical connection from electrodes on glass to a 22g wire.

See attached image -- it's the internals of a Nokia 5110 LCD.  At the bottom are the electrodes on the glass plate.



Does anyone know a good way to make this connection?  The electrodes are paper thin and the surrounding material is glass, so I don't think soldering is the answer.

Thanks in advance!

OM222O:
you do have to solder them! but not with normal methods. usually a hot bar is used to solder a flex cable to it. your only other option is welding bond wire which can not be done in a home application.

nickbild:
Thanks for the info.  I'm hoping there is a solution more within the reach of a low-skill hobbyist such as myself.  Maybe something along the lines of conductive glue reinforced with epoxy might work?  This is by no means for a commercial product.

oPossum:
The 5110 LCD uses a zebra strip. You don't have the whole assembly.

oPossum:

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod