Electronics > Projects, Designs, and Technical Stuff
Creepage/Clearance between wire wound inductor /pcb tracks
<< < (4/4)
jonpaul:
Hello again

I have used 2-5 mil mylar sheet, or 1-2 layers 3M #56 electrical tape.

In production, the material vendor (eg, EIS) can die-cut the mylar to and designed pattern.

Finally the inductor vendor may have a variation with insulated bottom or can supply an insulation pad.

Have you contacted the inductor manufacturer?

Jon
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod