Electronics > Projects, Designs, and Technical Stuff

Creepage/Clearance between wire wound inductor /pcb tracks

<< < (4/4)

jonpaul:
Hello again

I have used 2-5 mil mylar sheet, or 1-2 layers 3M #56 electrical tape.

In production, the material vendor (eg, EIS) can die-cut the mylar to and designed pattern.

Finally the inductor vendor may have a variation with insulated bottom or can supply an insulation pad.

Have you contacted the inductor manufacturer?

Jon

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod