Electronics > Projects, Designs, and Technical Stuff

Voltage level issue with CS5532/34 ADC

(1/1)

Tomkki:
Hello,
I just implemented python based driver for the the Cirrus Logic CS5531/32/33/34 ADC (https://www.cirrus.com/products/cs5531-32-33-34/). I followed the application note and hooked up a +-3V as VREF. The digital site is driven from 3V3 of the raspberry pi.

So far so good. My 20Hz sign wave looks pretty and I am able to sample with full speed (3200 SPS)

Now, when I start to make "many conversions" the amplitude of the signal collapses somehow (not deterministic when this happens).



You might have beed in the similar situation .. Is is a hardware or software issue?

Any idea what I could do to isolate the issue further?

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod