Electronics > Projects, Designs, and Technical Stuff
My constant current load - 90W , 3A 30V
<< < (7/19) > >>
blackdog:
Hi Spikee,

For the best sharing of the currents give eacht Fet a small Source resistor (0.1 Ohm)
And, don't forget to place the Fets on the good site of the heatsink!

This is the way to do it...


Kind regarts,
Blackdog
Spikee:
Can i use the wires as source resistor ?
i can 4-wire measure it to be exact.
robrenz:
Copper has a large resistance variation with temperature change so it would not be as good as a low temperature coefficient resistor
Spikee:
i have one laying around but another ... guess i will have to order another one from farnell.
blackdog:
Hi Spikee,

0.1 Ohm wire resistor... Mmmm

~ 9cm, copper wire, 0.1mm diameter.

Try it,

Kind regarts
Blackdog
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod