Electronics > Projects, Designs, and Technical Stuff
Drive NOKIA 5800 LCD
(1/1)
FAMELC:
Hi.
I want to drive NOKIA 5800 LCD with microcontroller but my problem is pinout details of LCD connector.
I mean, I have no documents or datasheet of it to undrestand about timing and protocol of LCD pins.
I also downloaded the relevant files like "Nokia service manual"(LCD pinout attached), but i cant undrestand CDP0 ck- or CDP0 ck+??
Why positive and negative is used??
Thanks a lot.
coromonadalix:
Some talks over there : https://www.raspberrypi.org/forums/viewtopic.php?t=46413
Prehistoricman:

--- Quote from: FAMELC on December 29, 2019, 06:59:35 pm ---I also downloaded the relevant files like "Nokia service manual"(LCD pinout attached), but i cant undrestand CDP0 ck- or CDP0 ck+??

--- End quote ---
Possibly LVDS (low voltage differential signals). One wire uses positive logic while the other uses negative logic.
FAMELC:
Thanks for answer

What is the voltage level for each pin?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod