Electronics > Projects, Designs, and Technical Stuff
Drving a SPDT 2 coil latching relay
<< < (4/6) > >>
Arjunan M R:
Does i need to care about back EMF in this relay?
Zero999:

--- Quote from: Arjunan M R on June 17, 2019, 12:31:16 pm ---Does i need to care about back EMF in this relay?

--- End quote ---
Yes, back-EMF protection diodes will be required, as the datasheet doesn't say they're built-in.
Arjunan M R:

--- Quote from: Zero999 on June 17, 2019, 12:50:15 pm ---
--- Quote from: Arjunan M R on June 17, 2019, 12:31:16 pm ---Does i need to care about back EMF in this relay?

--- End quote ---
Yes, back-EMF protection diodes will be required, as the datasheet doesn't say they're built-in.

--- End quote ---
Do i need to use a schotky diode?
If so will this be enough?
Here is the datasheet.
Arjunan M R:

--- Quote from: Arjunan M R on June 17, 2019, 12:54:22 pm ---
--- Quote from: Zero999 on June 17, 2019, 12:50:15 pm ---
--- Quote from: Arjunan M R on June 17, 2019, 12:31:16 pm ---Does i need to care about back EMF in this relay?

--- End quote ---
Yes, back-EMF protection diodes will be required, as the datasheet doesn't say they're built-in.

--- End quote ---
Do i need to use a schotky diode?
If so will this be enough?
Here is the datasheet.

--- End quote ---
I am already using that schotky diode if it's enough I don't have to increase the BOM cost.
Arjunan M R:
Does this mean that I can only energize the coil for max. of 10 ms :o.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod