Author Topic: DSLogic Pro Problems with clock  (Read 692 times)

0 Members and 1 Guest are viewing this topic.

Offline mriPaulTopic starter

  • Contributor
  • Posts: 16
  • Country: us
DSLogic Pro Problems with clock
« on: November 13, 2019, 04:49:06 am »
I have the DSLogic Pro and it works well so far. I have data with two pins. A CLK and data. I now have data I need to decode. I set the software to SPI and MOSI and 8bit protocol to decode the data. My data starts on a clean 8 bit packet. However, the software appears to decode the data with some random 5-6 bit protocol. I have attached a picture of the software showing my parameters.
Any ideas?
« Last Edit: November 13, 2019, 05:00:38 am by mriPaul »
 

Offline mriPaulTopic starter

  • Contributor
  • Posts: 16
  • Country: us
Re: DSLogic Pro Problems with clock
« Reply #1 on: November 13, 2019, 01:51:46 pm »
I found my issue. I had signal bounce. After zooming the data, I saw extra "square waves".
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf