Electronics > Projects, Designs, and Technical Stuff

DSLogic Pro Problems with clock

(1/1)

mriPaul:
I have the DSLogic Pro and it works well so far. I have data with two pins. A CLK and data. I now have data I need to decode. I set the software to SPI and MOSI and 8bit protocol to decode the data. My data starts on a clean 8 bit packet. However, the software appears to decode the data with some random 5-6 bit protocol. I have attached a picture of the software showing my parameters.
Any ideas?

mriPaul:
I found my issue. I had signal bounce. After zooming the data, I saw extra "square waves".

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod