Electronics > Projects, Designs, and Technical Stuff
DSP 5015 with/withouth USB port
(1/4) > >>
Blisk:
I have two DSP5015 one is with USB and another is withouth USB.
And when checking port there is no connector on DSP withouth USB. Is it possible I can just add connector and connect USB port on it or I also need to change firmware of that DSP? Did anyone try to upgrade it with USB port?
ESXi:
I don't really understand your question.
So you have a DSP 5015 without USB board?

Well, it's simple.

You need a CH340G Serial/USB chip, a few caps, resistors and a crystal.
Or if you don't want to do alot. Just buy the module or buy this cheap alternative;
https://aliexpress.com/item/Ch340g-usb-urt-ttl-adapter-voor-stc-downloaden-kabel/32863545192.html

I don't think you need to change firmware. I think the firmware is the same for both models.
Blisk:
I already have a module, question was If there are some changes in firmware.
I will test it.
ESXi:

--- Quote from: Blisk on September 27, 2018, 12:46:55 pm ---I already have a module, question was If there are some changes in firmware.
I will test it.

--- End quote ---

Ok. Can you give me a link to the firmware and I'll look at it when I have some spare time. I think they are the same, but I can't say for sure unless I look at the file itself.
Blisk:
Sorry don't know where firmware is for module.
I can only give a link what I have.
https://www.ebay.com/itm/DPS3012-DPS5015-DPS5020-Adjustable-Step-down-Regulated-LCD-Digital-Power-Supply/142832746230?hash=item21417ebef6:m:mDXiYJ4VD7E-F8PGqsO4dnQ
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod