EEVblog Electronics Community Forum
Electronics => Projects, Designs, and Technical Stuff => Topic started by: Old Grey on June 23, 2016, 01:47:19 am
-
This is probably a very simple question for you boffins, but bare with me as I'm only a beginner.
If I dual the LM1815 on one board am I doubling up on components on the 5V+ side, basically can I get rid of R15, R14, C13 and tap from the other circuit.
I made one circuit sch and just duplicated it, and wondered if I can cut down on parts because the board is small - has to be THT -.
(https://www.mediafire.com/convkey/7851/i3xe962vndvdb266g.jpg)