EEVblog Electronics Community Forum

Electronics => Projects, Designs, and Technical Stuff => Topic started by: bmi.bitmesra on November 28, 2016, 05:32:34 am

Title: ECG front end simulation
Post by: bmi.bitmesra on November 28, 2016, 05:32:34 am

Hello.
I want to simulate the ecg front end circuit but I dont know how am I gonna feed in the input so that i can get an ecg at the output stage. I found this circuit here on this forum and i am interested in developing it for my forthcoming mini project.  The circuit is attached. If I can simulate it using NI MultiSIM ? Also while I was trying to build the same in MultiSIM I was unable to find MCP6002 IC.
If you guys can help me it would be a big support.

Title: Re: ECG front end simulation
Post by: seekingforprogress on December 11, 2016, 09:02:54 pm

Hi!
I am searching ecg simulation,too. I need the desing and simulate an ecg circuit in protues or else but ? dont know how to add ad8236 into proteus and I dont know how can ? get the signal in the simulation instead of coming out   ecg probe that place on a human.

Title: Re: ECG front end simulation
Post by: trophosphere on December 12, 2016, 04:37:06 am

This page (http://www.microchip.com/wwwproducts/en/MCP6002) contains a link for the MCP6002's SPICE model (Expand the "documentation" section on the bottom and scroll all the way down until you see Spice Model).
This page (http://www.ni.com/example/30925/en/) from NI may help you in figuring out how to generate a custom signal for your simulation.