Electronics > Projects, Designs, and Technical Stuff

Enclosure for matrix board

<< < (2/2)

Boxgirl:
Hammond Electronics sell a wide range of Electronic enclosures. Maybe try contacting them? :)

rdl:
Personally, I'd toss the board and look for a better solution. Consider it a cheap lesson, when designing a project that will go in a box, start with the box and make everything else fit.

The Chump:
Thank you for your sage advice. Not quite what I asked for...

rdl:
Another possibility is the type of case where you slide the board into card guides instead of screwing it to posts. All you'd need to do is get the width reasonably close and make sure it's long enough and thick enough for the rest of your parts to fit.

Similar to this kit set up.

https://www.amazon.com/PR2H1-ProtoBoard-Box1-Kit-KBOX1-AC-SV-PR2H/dp/B00W865BGW/

themadhippy:

--- Quote ---Does anyone know of any plastic enclosures that have mounting posts compatible with these standard matrix boards
--- End quote ---
Buy a  suitable size  box and add your own mounting posts,either by drilling some holes and using nuts and bolts or if holes are a no, adhesive pillars

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod