Electronics > Projects, Designs, and Technical Stuff
"esd safe" insulating material?
(1/2) > >>
jeremy:
Hi,

I often have this problem, but don't know the proper answer to it, so I was hoping that someone could point me in the right direction.

I have a bare PCB which is being tested on an ESD mat. However, it seems that due to the conductivity of the ESD mat, there is some slight leakage which is affecting the measurements (I think...). What is a good material to put between the ESD mat and the PCB to insulate the two from eachother? Ideally, I'd like to put something like a 2mm thick piece of acrylic, but I know that acrylic is very good at holding static charge, so that's probably not a good idea  ;)
Siwastaja:
I would consider the pink "static dissipative" ESD bags for this purpose.

These bags are used to package ESD sensitive components inside their ESD shielding packs - the idea is, while they won't protect the components from ESD shocks (hence, external ESD control, like the ESD pack, or in your use case, your ESD mat, is needed), they won't generate charge themselves too easily.
Gyro:
It's pretty hard to build up a significant charge on cardboard.  :)
LukeW:
I think what you're asking for is intrinsically impossible.

Any good insulator will allow charge accumulation, and any ESD-dissipative material must be at least slightly conductive.

You have to find the right balance, the right tradeoff in the resistivity of the material, for your application.
helius:
Does your board have any mounting holes? Try elevating it above the mat using metal standoffs. That will provide a path for static charges to pass to ground (via the mat) but not load any sensitive nodes on the board.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod