Electronics > Projects, Designs, and Technical Stuff

ESD safe material

(1/2) > >>

tim510:

I need to test some photovoltaic (pv) cells that are on PCBs.  I would like to mount these on some type of board so that the pv  cells can be angled to test outside.  I think what I need is a material that would be esd safe and ideal to mount PCBs on.

Any suggestions would be appreciated.

Thanks.

Monkeh:
Uh.. perhaps a sheet of ply?

tim510:
I thought of ply. Maybe someone may have experience with some other types of  material. Some synthetic materials are cheaper. 

Thanks.

westfw:
I saved a goodly amount of pink and green anti-static shipping foam.  By the time you get slab a cm or two thick, it starts to get pretty rigid.  You can see some sitting under the "tower system" here: http://www.flickr.com/photos/58843278@N00/3866502441/#in/set-72157622049680333
I'm not sure where you'd get this if you had to buy it :-(

T4P:

--- Quote from: westfw on April 26, 2012, 08:17:39 am ---I saved a goodly amount of pink and green anti-static shipping foam.  By the time you get slab a cm or two thick, it starts to get pretty rigid.  You can see some sitting under the "tower system" here: http://www.flickr.com/photos/58843278@N00/3866502441/#in/set-72157622049680333
I'm not sure where you'd get this if you had to buy it :-(

--- End quote ---

Both RS and Farnell sells them .

Navigation

[0] Message Index

[#] Next page