Electronics > Projects, Designs, and Technical Stuff
Ethernet termination - bob smith for Board to board connection
(1/1)
rakeshm55:
Hi,
I have a 10/100 Eth running from one board to another via board to board connectors not standard Eth ports (RJ45 connectors)

Here I use Magnetics at both the boards.

 Eth PHY1 (board 1)----> Magnetics (board 1)-<---Board to board Connector----> Magnetics (board 2)-<-------- Eth PHY2(board 2)

 How to handle this bob smith termination to chassis ground. Here there is no chassis GND involved . Please advice.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod