Author Topic: Ethernet termination - bob smith for Board to board connection  (Read 673 times)

0 Members and 1 Guest are viewing this topic.

Offline rakeshm55Topic starter

  • Regular Contributor
  • *
  • Posts: 209
Ethernet termination - bob smith for Board to board connection
« on: September 12, 2019, 10:54:53 am »
Hi,
I have a 10/100 Eth running from one board to another via board to board connectors not standard Eth ports (RJ45 connectors)

Here I use Magnetics at both the boards.

 Eth PHY1 (board 1)----> Magnetics (board 1)-<---Board to board Connector----> Magnetics (board 2)-<-------- Eth PHY2(board 2)

 How to handle this bob smith termination to chassis ground. Here there is no chassis GND involved . Please advice.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf