Electronics > Projects, Designs, and Technical Stuff

Ethernet termination - bob smith for Board to board connection

(1/1)

rakeshm55:
Hi,
I have a 10/100 Eth running from one board to another via board to board connectors not standard Eth ports (RJ45 connectors)

Here I use Magnetics at both the boards.

 Eth PHY1 (board 1)----> Magnetics (board 1)-<---Board to board Connector----> Magnetics (board 2)-<-------- Eth PHY2(board 2)

 How to handle this bob smith termination to chassis ground. Here there is no chassis GND involved . Please advice.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod