So I am designing my first stm32 board (I know perfect timing), moving from the teensy 4.0. Before I start routing traces I was hoping someone could look over my schematic and make sure I didn't make any obvious mistakes. To give an idea of the goal for this is a modular synthesizer module. It has four outputs that come from a DAC through amplifiers to get them to 0-5v. It also has 5 gate inputs. there is also 7 buttons which have leds as well as multiple other leds. I have tested the buttons, gate inputs, leds, and dac with the teensy, I am just trying to move my project to an STM32. Ultimately my goal is to be able to program it through USB via a bootloader.