Electronics > Projects, Designs, and Technical Stuff
Generating Biphasic Signal with OpAamp
(1/6) > >>
A.Ersoz:
Hello,

I use TLV27L1 OpAmp in my circuit. I feed inverting and non inverting inputs with square waves. But as an output, I did not get biphasic signal. Current output of the opamp is just an monophasic sqaure waves. Do you have any idea why I miss negative phase of the signal?
SiliconWizard:
Can you show your input signals ("Phase 1", "Phase 2")?
patrick1:
wow, if this is possible without playing silly buggers with the ground reference, i would like too know about this too.
A.Ersoz:
Sure!
DaJMasta:
To actually verify that your circuit isn't doing what's intended, you need to compare the two channels together on the scope - one by one doesn't show anything about their phase relative to each other, and if they're in phase and combined, your opamp should only have a standard squarewave output.

I assume your intended output is a step function when the two input square waves are out of phase?  Right now your circuit is configured to attenuate the noninverting input by 1/3rd and apply a gain of 2 to the inverting input signal - I don't know if this is what you actually intended since the resistors chosen are the same values for each side.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod