Low Cost PCB's Low Cost Components

Author Topic: GL823 sd card reader, no response  (Read 1263 times)

0 Members and 1 Guest are viewing this topic.

Offline martin321

  • Contributor
  • Posts: 6
  • Country: no
GL823 sd card reader, no response
« on: November 29, 2015, 03:50:40 AM »
Hi,

I am trying to get the GL823 card reader to work, but there is no response from the pcb when I plug in the USB cable.
There is 3.3v DVDD, 1.5v on LED pin and nothing on PMOS or AVDD.
No resistors placed at R1 to R5.

Received the design guide and datasheet from supplier. Think I have correctly copied it.
gl823_sch.pdf is the one I have made.

If anyone could help me out I would relay appreciate it.

Martin
 

Offline martin321

  • Contributor
  • Posts: 6
  • Country: no
Re: GL823 sd card reader, no response
« Reply #1 on: December 07, 2015, 05:52:38 PM »
Found the post linked under. Anyone that can see my error?

https://www.eevblog.com/forum/beginners/issues-with-breadboard-sd-card-reader/
 

Offline mich41

  • Regular Contributor
  • *
  • Posts: 60
  • Country: 00
Re: GL823 sd card reader, no response
« Reply #2 on: December 09, 2015, 12:37:04 AM »
Quote
There is 3.3v DVDD, 1.5v on LED pin and nothing on PMOS or AVDD.
Hint: where the power to AVDD is supposed to come from? :)
 

Offline martin321

  • Contributor
  • Posts: 6
  • Country: no
Re: GL823 sd card reader, no response
« Reply #3 on: December 09, 2015, 03:21:09 AM »
Sorry, but I don't follow you.
 

Offline wraper

  • Supporter
  • ****
  • Posts: 5847
  • Country: lv
Re: GL823 sd card reader, no response
« Reply #4 on: December 09, 2015, 03:32:58 AM »
Sorry, but I don't follow you.
Do you expect AVDD to appear from nowhere  :palm:? It is externally connected to the chip. On the gl823_sch.pdf through the L1 inductor from the DVDD.
« Last Edit: December 09, 2015, 03:35:46 AM by wraper »
 

Offline mich41

  • Regular Contributor
  • *
  • Posts: 60
  • Country: 00
Re: GL823 sd card reader, no response
« Reply #5 on: December 09, 2015, 03:59:40 AM »
Well, DVDD does appear out of nowhere, so go figure :box:

Seriously though, page 16 of the datasheet kinda suggests that the internal 3.3V regulator outputs to DVDD and then note1 on page 12 tells that AVDD needs to be hooked up to that through a bead.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf