Electronics > Projects, Designs, and Technical Stuff

graphic equalizer with gyrator issue TL072

(1/1)

dave_j_fan:
this is an equalizer with gyrator elements.
i have tried to realize it with Tl072
opamp.
i made just for 60hz

how to connect it on 15 0 -15v

so far i have not been able to get clear audio via this.also pot for 60hz filter dont show any change when i vary.

ledtester:
Here's an article describing the circuit:

http://www.geofex.com/Article_Folders/EQs/paramet.htm

Note that in the other schematics Vb is defined by a voltage divider between +9 and GND:



So for adaptation for 15-0-15 I would use 15 for "+9", -15 for "GND" and 0 for "Vb".

dave_j_fan:
ok .thank u for very accurate reply.
i will try the same

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod