Electronics > Projects, Designs, and Technical Stuff
grease wire to wire shrink tube splice?
(1/1)
coppercone2:
If you make a wire splice by fusing two wires inline, do you put dielectric grease on the joint before heat shrinking it?

It's something new I saw and I wonder if one should bother. Does the heat shrink still work properly?
floobydust:
I think it's more of a psychological pacifier, seen it done for extra protection against oxidation. It doesn't always work, if the silicone grease can get washed out.
Some heatshrink needs around 260°C which I think melts the grease and it dribbles out. It's just messy.

I prefer to use thick-walled heatshrink which has hot glue inside. That seals up against water too.
It all depends on what you are sealing against- temperature, pressure, abrasion etc.
coppercone2:
yea the idea I think is for moisture resistance but do you get any significant ingress into a solder joint through a heat shrink and does the grease react with the sleeve material since its not really ideal? I thought it might cause it to decay by diffusion or something.

With crimp to crimp or butt splice crimp I understand because the tension varies with temperature cycles and it walks mechanically so you can imagine oxide creep in, since it will expand and show a bit of exposed skin, oxidize, then it won't be able to contract as well and then it might abrade and re oxidize and so on but I don't think the process is similar for solder joints.

How long does the grease last? Can't it act like a sponge to absorb hydrocarbons which make the plastic vulnerable?
I know some hot glues can absorb moisture and it begs the question, are the electronics grade hot glues/premade glue filled heat shrinks totally different or just better the normal hot glue?

To this point I have been using regular heatshrink twice over for that kind of joint. For commercial joints I used the solder thats built into heat shrink you attach with a hot air gun for speed (no glue in this).

Can the grease or phase change glue (or is it just viscosity change) actually make a connection worse over a LONG time scale?

Electronics grade silicones are different I think because they chemically cure to a tighter molecular structure (I think?)

Say you are using teflon wire.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod