« previous next »
Pages: [1]   Go Down

Author Topic: Channel Equalization in DSP processor  (Read 920 times)

0 Members and 1 Guest are viewing this topic.

Offline sagnikbasuTopic starter

  • Contributor
  • Posts: 19
  • Country: in
Channel Equalization in DSP processor
« on: March 06, 2017, 03:58:43 pm »
Hi.

I am trying to implement an adaptive channel equalization techniques to reduce noise and ISI effect of a channel in a DSP processor. I am using a Texas Instrument OMAP LCDK board for this project.

I need some guidance as I am quite new to the realm of Digital Signal Processors. Can anyone tell me how to proceed with this topic?

Thank you for your help.
Logged
 

Offline mark03

  • Frequent Contributor
  • **
  • Posts: 732
  • Country: us
Re: Channel Equalization in DSP processor
« Reply #1 on: March 06, 2017, 05:51:02 pm »
An adaptive filter is an extremely difficult first project to implement in hardware.  So many things can go wrong.  Start with a fixed FIR filters, verify, and go from there.
Logged
 
The following users thanked this post: sagnikbasu

Offline sagnikbasuTopic starter

  • Contributor
  • Posts: 19
  • Country: in
Re: Channel Equalization in DSP processor
« Reply #2 on: March 06, 2017, 06:09:56 pm »
Thanks .

If you know any good resource, do post their link.

Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee