Electronics > Projects, Designs, and Technical Stuff

Hameg 1004 Schematic & Calibration

(1/2) > >>

AngraMelo:
Hey guys,

I recently acquired a Hameg 1004-3. It needed some adjustments but I could not find any manuals or calibration procedures online. So, after 4 weeks of begging to Rohde & Schwarz they finally gave me.

Here you will find a detailed schematic, calibration process, board layout and anything you might need to fix or poke around the unit.

Hope Im posting this to the correct sub forum.

 PS: the file is bigger than 2mb so I posted it on scribd, if you need it somewhere else, send me the link of the website and Ill upload it there.

https://www.scribd.com/document/381437371/Hameg-1004-1004-3-Oscilloscope-Calibration-Manual-Board-layout

Gertjan:
Hi AngraMelo,

I have the same scope, so thank you very much  :)

For other people who want to download this manual: I found that you need to subscribe to Scribd before you can download. But they don't check the requested e-mailadress, so anything will do.... 8)

regards, Gertjan.

AngraMelo:
Hello my friend,

Im glad I could help! Do you have any other Hameg products?

Gertjan:
Hi AngraMelo,

For over 25 years I used an Hameg HM204-2 scope, and was very happy with it.
A few years ago the 20MHz bandwith of the HM204-2 became limiting, and I found the HM1004-3. (Also had to repair and (slightly) adjust mine).

I found 2 very nice things about Hameg: It is obvious that the Hameg designers are also oscilloscope users :)
Their scopes are easy to use, with just the right functions. And they are easy to repair. No special parts or modules like in other brands.

Regards, Gertjan.

AngraMelo:
Im also very happy with mine, so happy that I found a guy selling another one for very cheap and I got it as well. Now I have 2 and have no idea what to do with both units! hahahaha
best

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod