Electronics > Projects, Designs, and Technical Stuff

Help identifying my design flaw

<< < (4/4)

RarePossum:

--- Quote from: floobydust on July 20, 2024, 05:40:45 pm ---It's the crystal pin 1, I see a dot (or via?) wrong corner. Is the footprint correct?

--- End quote ---

That should be a via and its an SMD-3225 4P, which is what the store page and data sheet listed too.


--- Quote from: SiliconWizard on July 20, 2024, 10:13:20 pm ---One thing I'll have to check back, but that I'm wary about, is the RUN pin tied to the 3.3V rail. Not sure it's functional this way. Not saying it's not, but I'll check.

--- End quote ---

The docs say if no external reset is required, it can be directly tied to IOVDD and because I thought I shouldn't need to reset except for dev work, I connected it. Not the best idea but it should be fine

Navigation

[0] Message Index

[*] Previous page